English – 73
E
5. Remove the rear plate. (See page 72)
6. Remove the three screws (2) and washers, and
take off the cooler fan (3).
7. Remove the transmission drive belt from the belt
pulley.
POWER TRANSMISSION
Mounting
1. Fit the transmission drive belt on the belt
pulleys.
2. Fit the cooler fan (3), and the three screws (2)
and washers.
3. Push down the idler pulley (1) to stretch the
transmission drive belt and tighten while the belt
is stretched.
4. Fit the electric clutch. (See page 62)
5. Fit the rear plate. (See page 79)
1
2
3
Eng-4 sidan 55-102 97-04-11, 15.4073
To Next Page
Loading...
