52
AUTO-LENSMETER
4.6. PD TEST
PD value is not displayed…
PD value is so strange…
Check1
. Check right/left switching when you move LEVER
right and left compared to the center of PD.
Change PD MODULE
Y E S
Check1
.
Check that PD LEVER is in initial position before you turn the
power switch.
Y E S
Check1
. First, turn off the POWER switch and place PD LEVER in initial
position. And then turn on the power switch.
Information about initial position of PD
LEVER: After moving PD LEVER as left
as you can (initial position), turn on the
To Next Page
Loading...
Need help?
General
