Hyd-Mech M-16 - Input; Output Terminal Information; Inputs; Outputs; Encoder Connections

Pg 3. 18
Input / Output TInput / Output T
Input / Output TInput / Output T
Input / Output T
erminal Inferminal Inf
erminal Inferminal Inf
erminal Inf
ormaorma
ormaorma
orma
tion :tion :
tion :tion :
tion :
Inputs - X0 - Pop Down (H saw only) X10 - Aux. Vise Close Switch
X1 - Open X11 - Aux. Vise Open Switch
X2 - Blade Speed X12 - Front Vise Close Switch
X3 - Head Encoder, Channel A X13 - Front Vise Open Switch
X4 - Head Encoder, Channel B X14 - Head Raise
X5 - Head Down Limit X15 - Head Lower
X6 - Coolant Switch X16 - Blade Run
X7 - Coolant Switch X17 - Cycle Start
Outputs - Y0 - Machine Latch Y10 - Front Vise Close
Y1 - Swing Encoder (M saw only) Y11 - Front Vise Open
Y2 - Open Y12 - Open
Y3 - Pop Down Roller (H saw only) Y13 - Blade Run Relay & Blade Brush
Y4 - Aux. Vise Close Y14 - Open
Y5 - Aux. Vise Open Y15 - Open
Y6 - Coolant Pump Relay Y16 - Head Raise
Y7 - Cycle Pilot Light Y17 - Head Lower
ENCODER CONNECTIONSENCODER CONNECTIONS
ENCODER CONNECTIONSENCODER CONNECTIONS
ENCODER CONNECTIONS
(Connection at encoder viewed from back at soldered connections)
G
BK
R
W
F
A
B
E
C
D
LUCAS
ENCODER