Hyd-Mech S-25A - Lubrication

LUBRICATION
The design of the S-25A was intended to minimize maintenance, although periodically certain moving parts
need lubrication. We recommend that this periodic lubrication be done once a month using any general purpose
grease at the points indicated G.
Fig. 3-5 Vertical Pivot.
G
G
Fig. 3-6 Horizontal Pivot.
Fig. 3-7 90 Degree Shaft.
G
G
Fig. 3-8 Vise Ways.
Fig. 3-9 Idler Wheel Slider.
G
G
Fig. 3-10 Guide Arm Positioning Shaft.
G
3.2