SUB SECTION 2A - CONTROLS AND OPERATIONS
THE CONTROL CONSOLE
START-UP
The S-25A control console has been designed to simplify the operation of the saw, to give the operator the
ability to stop any function at any time, and to be able to control all the functions remotely. (See Fig. 2A-1)
We can not overstress the importance of familiarizing yourself with the controls of the S-25A prior to starting
the machine.
NOTE: WHEN STARTING THE S-25A FOR THE FIRST TIME
MAKE SURE
THAT THE MODE SELECTOR
SWITCH IS IN IT'S
NEUTRAL
POSITION, THE BLADE IS RUNNING IN A
COUNTER CLOCKWISE
DIRECTION, AND THAT THE HYDRAULIC PRESSURE IS
900 PSI
± 25 PSI (see SECTION 3
pg. 3.4).
Fig. 2A-1 Standard S-25A operation control panel.
S-25A MANUAL CONTROLS
HYDRAULIC START BUTTON: Starts hydraulic pump motor and energizes the BLADE START BUTTON
and the MODE SWITCH.
The fixed vise will open or close according to its selector switch position.
The actions of all other functions are dependent upon the MODE SWITCH
position. (see MODE SWITCH)
BLADE MOTOR This button is only operative when the hydraulic system has been
START BUTTON: started. Momentarily depressing this button will start the blade
motor.
BLADE MOTOR Momentarily depressing this button will stop the blade motor.
STOP BUTTON:
2.1
To Next Page