Hydac CS1000 series - Page 4

Content
Setting the measuring mode ...................................................................... 31
Mode M1: Continuous measurement ......................................................... 31
Mode M2: Continuous measurement and switching .................................. 31
Mode M3: Filter to cleanliness class and stop ........................................... 31
Mode M4: Filter to continuously monitor cleanliness class ........................ 32
Mode "SINGLE": Single measurement ...................................................... 33
Operating the CS1x2x sensor using the keypad ...................................... 34
Function of the Keys .................................................................................. 35
Measured variables on the display ............................................................ 36
ISO (Cleanliness class) .......................................................................... 36
SAE (Cleanliness class) ......................................................................... 36
NAS (Cleanliness Class - CS 13xx only) ................................................ 36
Service variables on the display ................................................................ 37
Flow (flow rate) ....................................................................................... 37
Out (Analogue output) ............................................................................ 37
Drive (performance of the LED).............................................................. 37
Temp (Temperature) .............................................................................. 37
Activate / deactivate keypad lock. .............................................................. 38
Display settings ..................................................................... 38
Activating display ............................................................... 39
Deactivating display ........................................................... 40
Menus and Mode ....................................................................................... 40
PowerUp Menu ....................................................................................... 41
Measuring Menu (CS12xx) ..................................................................... 45
- Display after sensor is switched on ............................... 46
– Configure switching output ........................................... 47
M1 – Continuous measurement ....................................................... 47
M2 – Continuous measurement and switching ................................ 47
M3 – Filter to cleanliness class and stop ......................................... 48
M4 – Filter to continuously monitor cleanliness class ...................... 48
SINGLE - Start single measurement + stop ..................................... 49
- Set output signal on analogue output ........................... 49
Measuring Menu (CS 13xx) ....................................................................... 51
- Display after sensor is switched on ............................... 52
– Configure switching output ........................................... 53
M1 - Continuous measurement ........................................................ 53
M2 – Continuous measurement and switching ................................ 53
M3 - Filter to cleanliness class and stop .......................................... 54
M4 - Filter to continuously monitor cleanliness class ....................... 55
SINGLE - Start single measurement + stop ..................................... 55
ContaminationSensor CS1000
en(us)
Page 4 / 136
BeWa CS1000 3764916d 300 en-us 2017-09-25.docx 2017-09-25