11
LEVELING YOUR HYDROPOOL SWIM SPA
After the swim spa is properly positioned on the support base, the entire unit should be checked and leveled as necessary.
Should you find that the unit is sloped or the base is otherwise uneven, level your swim spa using a 2”– 3” clear sand bed.
Make sure to enclose or ‘box-in‘ the sand to prevent erosion. This will ensure contact with the entire support base to appro-
priately distribute the weight of the swim spa structure. Do not adjust shim under the outside edge, as this will cause struc-
tural stress on the unit, potentially causing damage to the swim spa structure.
SET-UP & ASSEMBLY
Set-up of your swim spa will vary depending on whether you have purchased an Aquatrainer or Aquasport model. Once
your swim spa is set into place, you are ready to install the steel support legs and connect the equipment package.
STEEL SUPPORT LEG ASSEMBLY
Finger tighten the steel support legs before adding water to the swim spa. Do not adjust the steel support legs until water is
added to the swim spa.
STEEL SUPPORT LEG ASSEMBLY OVERVIEW
SIDE STEP FOOTWELL
14IX MODEL 8 1
14FX MODEL 8 1
17FX MODEL 10 1
19FX MODEL 10 1 1
1 Threaded post - protrudes below swim spa lip
2 Foot Assembly - includes foot plate & two hex nuts
3 Hex Nut Assembly
4 Square support leg
1
3
4
2
To Next Page
Loading...
