H Y D R O P O O L I N D U S T R I E S
27
STANDBY/DRAIN ASSIST
The standby/drain assist feature stops the system from
operating automatically, allowing for convenient filter
cartridge removal or for safe draining of the hot tub. The
following pads must be pressed within 2 seconds of each
other.
To put the system in standby,
Press Then
All functions will turn off, but P1 low speed can be
activated (by pressing the pad) to facilitate draining
the hot tub. Press any pad other than the ‘jets’ pad to return
the system to normal operation. See DRAINING YOUR HOT
TUB – p. 47 for detailed instructions.
MOOD LIGHTING
STANDARD MOOD LIGHTING
Press the pad on the topside control to turn the light
on and off.
LED MOOD LIGHTING OPTIONAL – FACTORY INSTALLED
Press the pad on the topside control to start the
selection of LED lighting modes. Pressing the pad
on/off within 3 seconds cycles through the various ‘light
shows’. When the LED lighting is turned off for more than 5
seconds, then turned back on, the system will resume the
last ‘light show’. For complete description of ‘light shows’,
see MOOD LIGHTING – p. 14
The system will automatically turn off the mood lighting
after 4 hours.
BLOWER OPTIONAL
Press this pad to turn the blower on and off. The system will
automatically turn off the blower after 15 minutes.
OZONATOR OPTIONAL
The ozonator operates during FILTER CYCLES and CLEAN-UP
CYCLES only (starts 2 minutes after filter cycle begins)
FREEZE PROTECTION
The system will automatically activate P1 low speed and
P2 if the water temperature in the equipment area drops
to 40˚F (4˚C).
To Next Page
Loading...
