Fault Finding 10
30 ST16135-00E
10.7 Controller Menus
In addition to P00 User Menu and P10 Customer Menu further
structures are only available to fully trained Hydrovane authorised
service engineers and are protected by access codes.
We strongly advise that no attempt is made to access these
structures, continued safe operation may be impaired and/or
serious damage may occur.
10.8 Oil Change Service Menu - P20
Configured for oil changes as part of a service agreement with an
authorised Hydrovane Distributor.
10.9 Service Engineers Menu - P21
For authorised engineers to install or service compressors as part
of an approved installation or maintenance program.
10.10 Diagnostic Menu - P22
Allows an authorised technician to check and test the inputs and
outputs to the Controller without running the compressor.
10.11 Drive Configuration Menu - P30
A parameter set to match inverter drive type and motor control
features that maintain operation within safe limits.
10.12 Factory Menu - P31
A master configuration menu that retains crucial default setting
parameters necessary for controlled safe operation.
If, for any reason, you feel unsure about fault rectification, or any
service aspect relating to your Hydrovane compressor, please
contact your nearest Hydrovane Distributor.
To Next Page
Loading...
