SETUP
0
powermax1000 Operator Manual 3-13
4. Find the power board. See figure below. Use insulated type 1/4" faston terminal ends to connect to
J15 & J16.
Note: 120VAC or 24 VAC must be sourced externally.
Signal: Arc Voltage (torch height control)
Type: Output
Notes: Full arc voltage. No voltage divider. 300VDC
maximum. (Signal not available on rear panel
connector.)
J15 +VDC
J16 -VDC
5. Tighten strain relief.
6. Replace cover
To Next Page
Loading...
