Hypertherm powermax1000

0
powermax1000 Operator Manual 4-1
Section 4
OPERATION
In this section:
Controls and Indicators .............................................................................................................................4-2
Indicator LEDs .................................................................................................................................4-2
Torch Consumable Configurations ............................................................................................................4-3
Installing Torch Consumables ...................................................................................................................4-4
Mode Switch..............................................................................................................................................4-5
Turn Power ON .........................................................................................................................................4-5
Check Indicator Lights...............................................................................................................................4-5
Adjust Gas Pressure and Current Setting .................................................................................................4-6
Hand Torch Operation ...............................................................................................................................4-7
Safety Trigger Operation .................................................................................................................4-7
Attach the Work Clamp....................................................................................................................4-8
Starting a Cut from the Edge of the Workpiece ...............................................................................4-8
Hand Torch Cutting Technique.........................................................................................................4-9
Piercing..........................................................................................................................................4-10
Gouging .........................................................................................................................................4-11
Cut Charts ...............................................................................................................................................4-12