OPERATION
0
4-8 powermax1000 Operator Manual
Attach the work clamp securely to the
workpiece. Remove rust, paint or other
coatings to ensure good electrical contact.
Attach the work clamp as close as possible
to the area being cut, to reduce exposure
to electromagnetic fields (EMF).
Do not attach the work clamp to the portion
that will fall away.
Starting a Cut from the
Edge of the Workpiece
Hold the torch nozzle vertical at the edge of
the workpiece.
Start cutting from the edge of the
workpiece.
Pause at the edge until the arc has
completely cut through the workpiece.
Then, proceed with the cut.
Attach the Work Clamp
WARNING
SPARKS AND HOT METAL CAN INJURE
EYES AND BURN SKIN
When firing the torch at an angle, sparks and hot metal will spray out from
the nozzle. Point the torch away from yourself and others.
To Next Page
Loading...
Need help?
General
