Hypertherm powermax1250 Service Manual

SPECIFICATIONS
4
2-6 powermax1250 Service Manual
Symbols and markings
S Mark
The S mark indicates that the power supply and torch are suitable for use in environments with increased hazard
o
f electrical shock. The hand torches must h
ave shielded consumable parts to maintain S mark compliance.
IEC symbols
The following symbols may appear on the power supply data plate, control labels and switches.
O
l
Direct current (DC)
The terminal for the external
protective (earth) conductor
AC input power connection
Plasma torch cutting and gouging
Alternating current (AC)
An inverter-based power
source
Volt/amp curve, “drooping”
characteristic
Power is OFF
Power is ON
Plasma torch in the
TEST
position (cooling and cutting
gas exiting nozzle)

Hypertherm powermax1250 Specifications

General

Brand	Hypertherm
Model	powermax1250
Category	Welding System
Language	English