OPERATION
10-99
powermax600
Operator Manual 4-9
Attach the work clamp securely to the
workpiece. Remove rust, paint or other
coatings to ensure good electrical contact.
Attach the work clamp as close as possible
to the area being cut, to reduce exposure to
electromagnetic fields (EMF).
Do not attach it to the portion that will fall
away.
Starting a Cut from the
Edge of the Workpiece
Hold the torch nozzle vertical at
the edge of the workpiece.
Start cutting from the edge of the
workpiece.
Pause at the edge until the arc has
completely cut through the
workpiece.
Then, proceed with the cut.
Attach the Work Clamp
To Next Page
Loading...
Need help?
General
