Hypertherm powermax600 - Powermax600 Operator Manual

3-6
SETUP
powermax600 Operator Manual
Gas Supply Connection
•
Use an inert gas hose to connect the gas supply (air or nitrogen) to the power supply gas inlet.
• Apply liquid pipe sealant to the threads to ensure a leak-free installation.
CAUTION: Do not use PTFE tape on pipe threads. Pieces of tape
can enter the air line and damage the system.
90 psi / 6.2 bar
208-240/480V
PMX600.11
90 psi / 6.2 bar
230/400V
Shipped with these
parts installed.
10-99