Table 1. Maintenance Schedule (Continued)
Item
No.
Item 8 hr/
Daily
500 hr/
3 mo
2000 hr/
1 yr
4000 hr/
2 yr
Procedure or
Quantity
Specification
Hinges, Levers,
Linkage, Pedals, Seat
Rails, and Latches
L Lubricate as
required.
See NOTE 2.
Use multipurpose
grease.
See NOTE 1 and
NOTE 13.
Hydraulic Control
Levers
L Lubricate as
required.
Use silicone
lubricant spray.
Hyster P/N 328388.
Heater- Air Filter C Replace air
filters. Quantity
of 2.
See Parts Manual.
Heater- Heater
Element
X Clean heater
element.
Use compressed air.
Heater- Operating
Condition
X Check operation
and heater
condition.
17 Integral Side-Shift
Carriage
(Upper/Lower
Bearings)
C Replace bearings/
4 bearings.
2.5 mm (0.098 in.)
minimum thickness.
See Parts Manual.
2 Steer Wheel Bearings L Check grease. Use multipurpose
grease.
See NOTE 1.
9 Hydraulic Oil Filter C 1 filter. See
NOTE 2 and
NOTE 8.
See Parts Manual.
19 Drive Axle Unit
Assembly
Gear Oil
C Change oil.
2.6 liter (2.7 qt)
total both
chambers.
Use gear oil John
Deere JDM J20C.
18 Lift Chains L Remove lift
chains to clean
and lubricate.
30W engine oil.
Steering Position
Sensor
X Check sensor
assembly and
column gear
teeth.
Replace sensor or
column gear as
required.
Telescopic Steering
Column
L Lubricate. Use manual
steering gear grease.
See NOTE 6.
X=Check C=Change L=Lubricate CIL=Check Indicator Light during operation
Maintenance Schedule 8000 SRM 1541
10
To Next Page
Loading...
