Hytera H Series User Manual

Troubleshooting
User Manual
28
Phenomena
Analysis
Solution
The positioning system
cannot locate your
position.
The radio may be at an unfavorable position,
so no position signal is received.
Move to an open and flat area, and try
again.
The BT device cannot be
paired.
The battery power of the BT device may be
low.
Recharge the BT device.
The BT device may be too far away from the
radio.
Move the BT device towards the radio.
During receiving, the voice
is weak, discontinuous, or
totally inactive.
The battery voltage may be low.
Recharge or replace the battery.
The volume may be low.
Increase the volume, or contact your
dealer to disable the Mic AGC feature.
The antenna may be loosened or installed
improperly.
Turn the radio off, and then reattach the
antenna.
The speaker may be blocked or damaged.
Clean the surface of the speaker.
Communications with
group members are
unavailable.
The frequency or signaling type may be
inconsistent with that of other members.
Set your TX/RX frequency and signaling
to the same as that of other members.
The channel type (digital/analog) may be set
inconsistently.
Make sure all members are on the same
digital/analog channel.
You may be too far away from the group
members.
Move towards other members.
The signal may be weak.
Make sure call participants are within the
communication range.
There is too much noise
and hiss.
The signal may be weak.
Make sure call participants are within the
communication range.
The radio may be in an unfavorable position.
For example, the signal may be blocked by
Move to an open and flat area, and then
restart the radio.

Hytera H Series Specifications

General

Brand	Hytera
Model	H Series
Category	Portable Radio
Language	English