Hytera PNC 550 - Date and Time

27
3.6 Date and Time
With network connected, you can enable automatic synchronization of date, time, and time zone of the
system. Or you can manually adjust them, if an error appears.
To configure date and time, tap System > Date & time, and then perform the following operations:

To enable automatic synchronization of date, time, and time zone, do as follows:
 Turn on the Automatic date & time switch, and then the system uses the date and time provided
by the network.
 Turn on the Automatic Time Zone switch, and then the system uses the time zone provided by
the network.

To manually adjust the date, time, and time zone, do as follows:
 Tap Set Date, and then select the date according to the actual situation.

Tap Set Time, and then rotate the clock pointer to set time, or tap in the lower left corner to
enter time.