DIGITAL jGUN REPAIR AND MAINTENANCE
Maintaining Hoses and Fittings
• Visually inspect air lines and air line ttings before tool use.
• Replace worn or leaking air lines.
• Tighten leaky ttings.
Lubricating the Air Motor
To lubricate the air motor:
1. Turn the Digital jGun upside down and disconnect the air hose at the regulator coupling con-
nection.
2. Pour approximately one ounce (29.6 ml) of air tool oil, or spray a lubricant, into the hose
coupling on the gun.
3. Reconnect the hose and operate the gun, while standing clear of the exhaust opening at the
base of the handle. Excess lubricant will release from this opening upon initial operation.
*For additional maintenance instruction, refer to the HYTORC Tool Maintenance Guidelines
!! CAUTION !!
LOOSE FITTINGS CAN BE POTENTIALLY DANGEROUS WHEN PRES-
SURIZED. OVER TIGHTENING FITTINGS CAN CAUSE PERMANENT
THREAD FAILURE.
LOOSE FITTINGS OR OVER TIGHTENED FITTINGS CAN CAUSE PER-
SONAL INJURY AND TOOL DAMAGE.
ENSURE THAT AIR LINE FITTINGS ARE TIGHT, BUT NOT OVERLY TIGHT.
NOTE
The air motor does not require continuous lubrication, however it is rec-
ommended that air tool oil be occasionally applied to the tool.
21
BREAKTHROUGH PRODUCTS FOR INDUSTRIAL BOLTING
To Next Page
Loading...
Need help?
General
