Hytorc Stealth 2 - Interconnect Reaction Arm; Holding Plate

5.3 Interconnect reaction arm
Procedure
1. Place the reaction arm as shown.
2. Place the tools over the nuts as far
as possible.
5.4 Holding plate
The holding plate allows to use double-drive. Multiple variants are available for use with
the HYTORC Washer
TM
or HYTORC LoadDISC
TM
.
Procedure
1. Place the HYTORC Washer
TM
or
HYTORC LoadDISC
TM
under the
regular nut.
2. Place the tool with the holding plate
over the nut and reaction washer
completely.
Reaction arms
37 - 001 - 25