EasyManuals Logo

i-SENS TEE2 User Manual

i-SENS TEE2
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
8 www.i-sens.com
www.spirit-healthcare.co.uk 9
The TEE2 Meter comes with two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When using your meter and seeing the
symbol appear on the
display for the first time, the batteries should be replaced as soon as
possible. The test results might not be saved if the batteries run out.
Inserting or Replacing the Batteries
Note:
•Removing the meter batteries will not affect your stored
result. However, you may need to reset your meter settings.
See pages 14-16 .
Caring for Your System
Useasoftclothortissuetowipethemeterexterior.Ifnecessary,
the soft cloth or tissue might be dipped in a small amount of
alcohol.
Do not use organic solvents such as benzene, or acetone, or
household and industrial cleaners that may cause irreparable
damage to the meter.
Caution:
• Donotexposethemetertodirectsunlightheat,orexcessive
humidityforanextendedperiodoftime.
• Donotletdirt,dust,blood,orwaterenterintothemeter’s
test strip port.
• Donotdropthemeterorsubmitittostrongshocks.
• Donottrytofixoralterthemeterinanyway.
• Keepthemeterawayfromstrongelectromagneticfields
such as cell phones and microwave ovens.
• TEE2metershouldbeusedonlywithTEE2strips.
• Keepthemeterinacoolandwellventilatedplace.
• Storeallthemetercomponentsintheportablecaseto
prevent loss and help keep the meter clean.
Step 1
Make sure the meter is turned off. Push the
cover in the direction of the arrow to open
the battery compartment.
Step 2
Remove the old batteries one by one by
liftingwiththeindexfingerandpullingit
outwithyourthumbandindexfingersas
shown in the figure on the right. Insert two
new batteries with the + side facing up and
make sure the batteries are inserted firmly.
Step 3
Place the cover on the battery
compartment. Push down until you hear
the tab click into place.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the i-SENS TEE2 and is the answer not in the manual?

i-SENS TEE2 Specifications

General IconGeneral
Brandi-SENS
ModelTEE2
CategoryBlood Glucose Meter
LanguageEnglish

Related product manuals