i-SENS TEE2 User Manual

22 www.i-sens.com
www.spirit-healthcare.co.uk 23
Caution:
To avoid infection when drawing a sample, use a lancet only
one time, and:
•Donotusealancetthathasbeenusedbyothers.
•Alwaysuseanewsterilelancet.
•Keepthelancingdeviceclean.
Note:
•Repeated puncturing at the same sample site may cause
pain or skin calluses (thick hard skin). Choose a different
site each time you test.
Using the Lancing Device
You will need a lancing device in order to collect a blood sample.
You may use the lancing device contained in the TEE2 Blood
Glucose Monitoring System or any other medically approved
lancing device.
• Thelancingdeviceshouldnotbeusedbymorethanone
individual. Ensure the lancing device is not shared among
different users.
• Useasoftclothortissuetowipethelancingdevice.
If necessary, a small amount of alcohol on a soft cloth or
tissue may be used.
Adjustable Tip
Lancet Holder
Sliding BarrelRelease Button
Ejection System
Lancet
Step 1
Wash hands and sample site with
soap and warm water. Rinse and dry
thoroughly.
Step 2
Unscrew and remove the lancing
device tip.
Step 3
Firmly insert a new lancet into the
lancet holder. Hold the lancet firmly.
Gently twist to pull off protective disk.
Save disk to recap lancet after use.
Replace lancing device tip.
Preparing the Lancing Device

i-SENS TEE2 Specifications

General

Brand	i-SENS
Model	TEE2
Category	Blood Glucose Meter
Language	English