IAR SYSTEMS I-jet - The I-Jet In-Circuit Debugging Probe

To Next Page

To Previous Page

AFE1_AFE2-1:1

Introduction

IAR Debug Probes User Guide

I-jet®, I-jet Trace, and I-scope™

THE I-JET IN-CIRCUIT DEBUGGING PROBE

I-jet connects to the target board via a JTAG, SWD, or cJTAG connection, and to the

host computer via the USB port.

I-jet communicates using USB 2.0. (USB 1.0 is also supported but not recommended.)

The I-jet in-circuit debugging probe is also referred to as a debug probe, debug adapter,

or JTAG in-circuit emulator by different tool vendors.

C-SPY debugger

C-SPY driver

USB connection

I-jet

JTAG, SWD

or cJTAG