IBM 8863 - eServer xSeries 366 - Page 42

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, “Parts listing, Type 8863,” on page 93 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only)”, that step must be performed only by a
trained service technician.
Error code Description Action
0001295 ECC circuit check.
1. Reseat the following components:
a. DIMM
b. Memory card
2.
Replace the components in step 1 one at a time,
in the order shown, restarting the server each
time.
00012000 Processor machine check error.
1. Reseat the following components:
a. (Trained service technician only)
Microprocessor
b. Microprocessor tray
2.
Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. (Trained service technician only)
Microprocessor
b. (Trained service technician only)
Microprocessor tray
00019501 Processor 1 is not functioning; check
processor LEDs.
1. Reseat the following components:
a. Microprocessor tray
b. (Trained service technician only)
Microprocessor 1
2.
Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. (Trained service technician only)
Microprocessor 1
b. (Trained service technician only)
Microprocessor tray
00019502 Processor 2 is not functioning; check
processor LEDs.
1. Reseat the following components:
a. Microprocessor tray
b. (Trained service technician only)
Microprocessor 2
2.
Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. (Trained service technician only)
Microprocessor 2
b. (Trained service technician only)
Microprocessor tray
26 IBM xSeries 366 Type 8863: Problem Determination and Service Guide