Check Procedures 2-7
009 -
−
If the last test stops and you cannot continue, first make sure all
switches, power connectors, cables, and jumpers are set correctly
and show the correct voltages and continuity.
−
Take note of any messages, error codes, beeps, or new symptoms.
Go to "Index of Symptoms, Messages, Error Codes, or Beeps" on
page 2-8.
−
If there is no error symptom or the error symptom is intermittent, go
to “Undetermined Problems” on page 2-42.
To Next Page
Loading...
Need help?
General
