v See Chapter 4, “Parts listing, Types 7871 and 1949,” on page 41 to determine which components are CRUs and
which components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Symptom Action
You suspect a software
problem.
1. To determine whether the problem is caused by the software, make sure that:
v The blade server has the minimum memory that is needed to use the
software. For memory requirements, see the information that comes with the
software.
Note: If you have just installed an adapter or memory, the blade server
might have a memory-address conflict.
v The software is designed to operate on the blade server.
v Other software works on the blade server.
v The software works on another server.
2. If you receive any error messages while you use the software, see the
information that comes with the software for a description of the messages and
suggested solutions to the problem.
3. Contact your place of purchase of the software.
Chapter 6. Diagnostics 179
To Next Page
Loading...
