Table 9. Methods for viewing event logs
Condition Action
The blade server is not hung. Use any of the following methods:
v In a Web browser, type the IP address of
the advanced management module and
go to the Event Log page.
v Run Portable DSA to view the event logs
or create an output file that you can send
to IBM service and support.
v Use IPMItool to view the system-event
log.
The blade server is hung.
v If DSA Preboot is installed, restart the
blade server and press F2 to start DSA
Preboot and view the event logs.
v If DSA Preboot is not installed, insert the
DSA Preboot CD and restart the blade
server to start DSA Preboot and view the
event logs.
v Alternatively, you can restart the blade
server and press F1 to start the Setup
utility and view the POST event log or
system-event log. For more information,
see “Viewing event logs through the
Setup utility” on page 99.
IMM error messages
Use this information to resolve IMM error messages.
The following table lists IMM error messages and suggested actions to correct the
detected problems.
Note: An updated list of IMM error messages and corrective actions are available
on the IBM website at http://www.ibm.com/systems/support/supportsite.wss/
docdisplay?lndocid=MIGR-5079338&brandind=5000008.
Chapter 6. Diagnostics 101
To Next Page
Loading...
Need help?
General