EasyManua.ls Logo

IBM Elastic Storage System 5147-102

IBM Elastic Storage System 5147-102
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 7. MES upgrade from hybrid-x to hybrid-y
Target ->
Source
P (f)
24
NVMe
H1
(h, h)
12
NVM
e
1 X
52
HDD
H1
(h, f)
12
NVM
e
1 X
102
HDD
H2
(h, f)
12
NVM
e
2 X
102
HDD
H3 (h,
f)
12
NVMe
3 X
102
HDD
H4
(h, f)
12
NVM
e
4 X
102
HDD
H1 (f,
h)
24
NVMe
1 X 52
HDD
H1
(f, f)
24
NVM
e
1 X
102
HDD
H2 (f, f)
24
NVMe
2 X 102
HDD
H3 (f,
f)
24
NVMe
3 X
102
HDD
H4
(f, f)
24
NVM
e
4 X
102
HDD
H1 (h, h) Y
(NC)
Y
H1 (h, f) Y Y
H2 (h, f) Y Y Y
H3 (h, f) Y Y
H4 (h, f) Y
H1 (f, h) Y
(NC)
H1 (f, f) Y
H2 (f, f) Y Y
H3 (f, f) Y
H n (h, h)= Hybrid, half performance + n x half populated 5147-102
H n (h, f)= Hybrid, half performance + n x full populated 5147-102
H n (f, f)= Hybrid, full performance + n x full populated 5147-102
NC = Non concurrent
Refer to the following steps to add more 5147-102 storage enclosures to an existing hybrid conguration:
1. An ESS 3500 solution in hybrid conguration has at least one SAS adapter pair. Perform 5141-FN2
adapter MES instructions to install additional pair of SAS adapter if required. Refer ESS 3500 adapter
concurrent MES upgrade to follow the instructions.
2. If you are adding a new SAS adapter pair, re-cabling is required. Refer “Re-cabling guidelines from
single SAS adapter pair to dual SAS adapter pairs ” on page 41.
3. Install up to four empty 5147-102 storage enclosures to rack.
4. Populate the storage enclosure(s) with HDDs making sure to follow the drive population rules.
a. One to four fully populated 5147-102 storage enclosures.
If the rst enclosure is half-populated conguration, upgrade to a fully populated conguration
before adding additional enclosures. Refer “Upgrading an IBM Elastic Storage System 5147-102
Storage Enclosure from a half-populated to a fully populated conguration” on page 6.
b. Use at least one SAS adapter per canister for 1 to 2 enclosures,.
c. You need two SAS adapter pairs in order to connect three or more enclosures.
Note: All enclosures must have identical number of HDDs.
5. Connect 5141-FN2 and 5147-102 enclosures.
32
IBM Elastic Storage System 5147-10 Storage Enclosure: Service Guide

Table of Contents

Related product manuals