184 IBM Power 770 and 780 (9117-MMD, 9179-MHD) Technical Overview and Introduction
4.3.5 Locating and servicing
The final component of a comprehensive design for serviceability is the ability to effectively
locate and replace parts requiring service. POWER processor-based systems use a
combination of visual cues and guided maintenance procedures to ensure that the identified
part is replaced correctly, every time.
Packaging for service
The following service enhancements are included in the physical packaging of the systems to
facilitate service:
Color coding (touch points)
– Terra-cotta-colored touch points indicate that a component (FRU or CRU) can be
concurrently maintained.
– Blue-colored touch points delineate components that are not concurrently maintained
(those that require the system to be turned off for removal or repair).
Tool-less design: Selected IBM systems support tool-less or simple tool designs. These
designs require no tools or require basic tools, such as flathead screw drivers to service
the hardware components.
Positive retention: Positive retention mechanisms help to ensure proper connections
between hardware components, such as from cables to connectors, and between two
cards that attach to each other. Without positive retention, hardware components run the
risk of becoming loose during shipping or installation, preventing a good electrical
connection. Positive retention mechanisms such as latches, levers, thumb-screws, pop
Nylatches (U-clips), and cables are included to help prevent loose connections and aid in
installing (seating) parts correctly. These positive retention items do not require tools.
Light Path
The Light Path LED feature is for low-end systems, including Power Systems up to models
750 and 755, that can be repaired by clients. In the Light Path LED implementation, when a
fault condition is detected on the POWER7 or POWER7+ processor-based system, an amber
FRU fault LED is illuminated, which is then rolled up to the system fault LED. The Light Path
system pinpoints the exact part by turning on the amber FRU fault LED that is associated with
the part to be replaced.
The system can clearly identify components for replacement by using specific component
level LEDs, and can also guide the servicer directly to the component by signaling (remaining
solid) the system fault LED, enclosure fault LED, and the component FRU fault LED.
After the repair, the LEDs shut off automatically when the problem is fixed.
Guiding Light
Midrange and high-end systems, including models 770 and 780 and later, are usually
repaired by IBM Support personnel.
The enclosure and system identify LEDs that are on solid, and can be used to follow the path
from the system to the enclosure and down to the specific FRU.
Guiding Light uses a series of flashing LEDs, allowing a service provider to quickly and easily
identify the location of system components. Guiding Light can also handle multiple error
conditions simultaneously, which might be necessary in some complex high-end
configurations.
To Next Page
Loading...
Need help?
General