Removing and replacing covers on the 5148-21L, 5148-22L, 8247-21L,
8247-22L, 8247-42L, 8284-21A, 8284-22A, 8286-41A, or 8286-42A system
Use these instructions to remove and replace the covers for a 5148-21L, 5148-22L, 8247-21L, 8247-22L,
8247-42L, 8284-21A, 8284-22A, 8286-41A, or 8286-42A system so that you can access the hardware parts or
perform service.
Removing the front cover
Use these instructions to remove the front cover from a 5148-21L, 5148-22L, 8247-21L, 8247-22L, 8247-42L,
8284-21A, 8284-22A, 8286-41A, or 8286-42A system so that you can access the hardware parts or perform
service.
Removing the front cover from a rack-mounted 5148-21L, 5148-22L, 8247-21L,
8247-22L, 8284-21A, or 8284-22A system
Use this procedure to remove the cover from a rack-mounted system so that you can access the
components or perform service.
To remove the front cover, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Remove the two shipping screws (A) (if present) that secure the system to the rack.
Note: Replacing the shipping screws is optional but should be done in geographic areas that are
prone to seismic activity.
3. Pull the cover away from the system. The cover has an indentation where you can hold onto it more
easily.
Removing the front cover from a rack-mounted 8247-42L, 8286-41A, or 8286-42A
system
Use this procedure to remove the cover from a rack-mounted system so that you can access the
components or perform service.
To remove the front cover, complete the following steps:
Figure 129. Removing the front cover
148 Disk drives or solid-state drives
To Next Page
Loading...
Need help?
General