IBM Selectric - Page 115

2
Figure 8. Belt Replacement
ure 11) making sure all the latches are under the bail.
Insert a bristol wrench through the lower left bearing
plate mounting hole over the top of the bail to hold it
down.
13. Loosen the two cycle-clutch latch-bracket mounting
screws (#1, Figure 10). Slip the new b elt through the
beari ng pi ate hoi e, around the shaft, and over across
the cycle shaft to the cycl ' e-clutch latch (Figure 11).
Work it between the latch and the cycle-clutch sleeve.
14. Loosen the motor mount and sl ip the belt over the cen-
2
3
Figure 9. Belt Replacement
3-3
Figure 10. Belt Replacement
trifugal clutch.
15. The following adjustments should be checked after the
belt is replaced:
a. Idler gears
b. Damper spring
c. Filter shaft timing
d. Print shaft timing
e. C 1 and C2 contact timing
f. Cycle clutch latch bracket height
Figure 11. Belt Replacement