IBM Selectric - Latch Pusher Removal; Print Magnet Assembly Removal

PRJ NT MAGNET ASSEMBLY REMOVAL
1. Disconnect the cycle-clutch trip link (#1, Figure 36).
2. Remove the support leg in the lower left corner (#2, Fig-
ure 36).
3. Remove the four mounting screws (#3, Figure 36).
4. Carefully remove the magnet assembly.
Figure 36. Print Magnet Assembly Removal
3-11
LATCH PUSHER REMOVAL
1. Remove the two screws (#1, Figure 37) that hold the con-
tact plate to the frame. Remove the contact assembly,
holding it to the front with a rubber band.
2. Disconnect the pusher springs (#1, Fig\Jre 38).
3. Remove the C-clip on the end of the shaft (#2, Figure 38)
and remove the shaft until the desired pusher is free.
4. The following adjustments should be' checked after a latch-
pusher is replaced.
a. Latch to pusher clearance
b. Latch-pusher to armature clearance
Figure 37. Latch Pusher Removal
Figure 38. Latch Pusher Removal