IBP HDM97BQ User Manual

Base Installation
14
Basic settings
To invoke the installation menu please follow the steps below:
1. Switch on the meter using the key.
2. Press during the display test.
3. After this procedure the instruments starts the basic settings dialog instead of entering any measurement
functions.
4. In the basic settings dialog you are able to adjust a variety of settings.
Parameter
Meter Versions
Description
AUTO-OFF
All
Set the delay time fort he auto power off function or disables it.
BEEP
All
enables / disables the keypad acknowledge beep
CAL-RES
All
Overwrites the user calibration dataset with the device initial
calibration dataset.
LANGUAGE
All
Adjusts the display language.
PHT
BO, BP, BQ
Target time adjustment for pressure holt test (PHT)
TIMER
All
enables / disables the stopwatch function
Flow
BL, BQ
enables / disables the Flow channel
pH
BP
enables / disables the pH channel
TEMP
BN, BO, BP, BQ
enables / disables the sole readout of the temperature channel
PR HR-Res
BH, BO, BP, BQ
enables / disables the high resolution for pressure channel
→ AUTO-OFF
→ OFF → disables function
→ 30 MIN → 30 minutes delay
→ 60 MIN → 60 minutes delay
→ 90 MIN → 90 minutes delay
Then to apply and save this setting,
or to discard this setting.
→ BEEP
→ ON → keypad beep enabled
→ OFF → keypad beep disabled
Then to apply and save this setting,
or to discard this setting.

IBP HDM97BQ Specifications

General

Brand	IBP
Model	HDM97BQ
Category	Measuring Instruments
Language	English