DX8
Dual Balance Charger/Discharger/DC Power
Error Messages
The input voltage is too high
The input voltage is too low
The output voltage is too high
The voltage of the connected battery is too low
The voltage of the connected battery is too high
"The internal temperature is too high"
The internal temperature is too high
"The internal temperature is too low"
The internal temperature is too low
"Battery polarity reversed!"
Battery has been connected with polarity reversed.
Internal control checking error
Safe time limit is exceeded
"Exceed safe capacity limit"
Safe capacity limit is exceeded
"Exceed safe temperature range"
Safe temperature range is exceeded
"Output connection broken"
Output connection is broken
"Balance port connection error"
Balance port has a connection error
"Low cell voltage detected on balance port"
Low cell voltage is detected on balance port
"High cell voltage detected on balance port"
High cell voltage is detected on balance port
"Voltage match error. Balance port sum is
lower than output."
Voltage matched error, the voltage of the balance port
sum is lower than the output one
"Voltage match error. Balance port sum is
higher than output."
Voltage matched error, the voltage of balance port sum
is higher than the output one
"Number of cells doesn't match the setting"
Number of cells connected doesn't match the setting
"Number of cells setting appears low"
Number of cells setting appears low
"Number of cells setting appears high"
Number of cells setting appears high
"Balance not needed, Remove connection
from balance port"
Balance port error, Ni-, Pb does not need balance port,
but voltage of balance port is detected
Balance port is unplugged
"Auto detect the number of cells failed, please
connect balance or set cells"
Check connection or balance port
To Previous Page
Loading...
