To Next Page

To Previous Page

Remote or Outdoor Sensor Installation (Optional)

1. Remove cover from remote sensor housing.

2. Select an appropriate location for mounting the remote sensor.

3. Mount remote sensor unit using hardware provided.

4. Install two strand shielded wire between remote sensor and thermostat. Shielded wire must be used. Do not

run remote sensor wire in conduit with other wires.

• Wire 1 should run between the S1 terminal on the thermostat and the S1 terminal on the remote sensor

• Wire 2 should run between the S2 terminal on the thermostat and the S2 terminal on the remote sensor

• Connect the shielding of the wire to the S2 terminal on the thermostat

5. Conﬁgure the thermostat to operate with the remote sensor (see Conﬁguration Mode setting 10, Page 14).

Note: Remote or outdoor sensor reading can be displayed by

simultaneously pressing the Down and SYS buttons.

Remote Sensor: (Shown: Optional ICM ACC-RT103 Remote Indoor Sensor;

for outdoor sensor, order ACC-OD103.)

ICM Controls SC 5011 User Manual

Questions and Answers: