4
MEMORY OPERATION
4-3
You can enter contents into the Memory channels
in the VFO mode, depending on the transceiver’s
presettings.
1. Setting the frequency in the VFO mode
1) Set the MHz digit.
➥ Push [ /MHz/GRP], and then push [∫] or [√].
• The MHz digit blinks.
2) Exit the MHz digit Selection mode.
➥ Push [ /MHz/GRP] again.
3) Set the kHz digit.
➥ Push [∫] or [√].
2. Entering a memory name (p. 7-3)
1) Open the “MEMORY NAME” item.
MENU > MEMORY WRITE > MEMORY NAME
2) Enter a desired name.
➥ Push [∫] or [√] to select the desired character.
• Push [SCAN] to select the character group.
You can enter the characters listed below.
A to Z, a to z, 0 to 9, (space)
! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ~
• Push [MENU/CLR] to clear the entered character.
• Push [PRI/DUAL] to move the cursor to the left, and
push [SQL] to move the cursor to the right.
• You can enter up to 12 characters.
3) Return to the “MEMORY WRITE” menu.
➥ Push [ ]/[MHz]/[GRP].
3. Setting the Lockout setting (p. 7-3)
Select whether or not to lockout the selected channel
while scanning.
1) Open the “LOCKOUT” item.
➥ Push [∫] or [√], and then [ ]/[MHz]/[GRP].
2) Select the Lockout setting for the channel.
➥ Select “OFF” or “ON” and then push
[ ]/[MHz]/[GRP].
• Returns to the “MEMORY WRITE” menu.
Entering contents into the Memory channels
4. Selecting a group (p. 7-3)
Select the group to store the selected channel in.
You can select one of up to 10 groups, depending on
the transceiver’s setting.
1) Open the “GROUP” item.
➥ Push [∫] or [√], and then [ ]/[MHz]/[GRP].
• The group list is displayed.
2) Select a desired group.
➥ Push [∫] or [√], and then [ ]/[MHz]/[GRP].
• Returns to the “MEMORY WRITE” menu.
5. Writing the contents into the Memory channel
Select the “WRITE” item and then push
[ ]/[MHz]/[GRP].
NOTE: The VFO mode is for only EXP, USA, and
EUR versions. If you are using the transceiver
without the VFO mode, you cannot enter the
contents into memory channels.
To Next Page
Loading...
Need help?
General
