To Next PageTo Next PageWhy doesn't the programmed scan stop on my Icom I706MKTMG?
If the programmed scan on your Icom Transceiver doesn't stop, it could be because the squelch is open; set it to the threshold position. Another reason might be that the same frequencies have been programmed in scan edge memory channels; program different frequencies into these channels.
General| Brand | Icom |
|---|---|
| Model | I706MKTMG |
| Category | Transceiver |
| Language | English |
Safety and operational warnings for using the transceiver, including power, environment, and usage.
Detailed description of the transceiver's front panel buttons, knobs, and display.
Explanation of M1, M2, M3, and M4 function switch groups and their capabilities.
Details on function switches for VOX, AGC, Filters, Noise Blanker, and DSP.
Detailed description of all rear and side panel connection ports.
Explanation of various indicators on the transceiver's function display.
Description of the HM-103 microphone controls and technical information.
Initial setup steps including unpacking, grounding, and antenna connection.
Guidance on single body mounting, using the stand, and separating the front panel.
Diagram showing essential connections for basic operation.
Connecting various accessories like headphones, speakers, and optional units.
Instructions for connecting Icom and non-Icom power supplies, and vehicle batteries.
Wiring diagrams for connecting automatic antenna tuners and linear amplifiers.
Procedure for initial power-up, CPU reset, and initial settings.
Explanation of VFO and Memory modes and their differences.
Guide to selecting and installing optional IF filters for improved selectivity.
Using Automatic Notch Filter (ANF) and Noise Reduction (NR) for signal clarity.
Adjusting output power, microphone gain, and using the meter function.
Instructions for operating the AT-180 tuner, including manual tuning and features.
Instructions for operating the AH-4 tuner, including tuning and PTT tune function.
Setting up split frequency and repeater operations, including quick split.
Setting up CW mode, connections, break-in, and pitch control.
Introduction to Quick Set Mode and Initial Set Mode for configuration.
Solutions for problems related to power supply and no sound from speaker.
Troubleshooting steps for low sensitivity and distorted receive audio.
Solutions for transmitting problems, low output power, and no contact.
Troubleshooting for display problems and scan operation errors.
