BASIC MANUAL
6
Mode Select
All the operating modes are ON as default.
RF/SQL VR
•
Beep
Beep Level
•
Band Edge Beep
Turns the Band Edge Beep ON or OFF.
Side Tone Level
Adjusts the CW side-tone output level
•
L
Meter Peak Hold
Turns the Meter Peak Hold function ON or OFF.
Scan Speed
Sets the scan speed.
•
SCAN Resume
signal is detected, 2 seconds after the signal disappears, the scan resumes.
AM Noise Blanker
Turns the Noise Blanker function in the AM mode ON or OFF.
L
Auto TS
Key Type
Selects the CW paddle type.
•
Tuner Type (TUNER)
Selects the tuner type when an optional antenna tuner is connected.
•
Auto Tune
L When the function is ON, an automatic tune starts even when the tuner is turned OFF.
Initial Set mode items
To Next Page
Loading...
