Icom IC-M506EURO

New2001
8
3
PREPARATION
New2001New2001
The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be programmed at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been pro-
grammed, this programming is not necessary.
Push [MENU]. q
Rotate dial or push [ w Ω]/[≈] to select the “RADIO SET” icon
and then push the softkey below the icon.
 •RADIOSETTINGSmenuisdisplayed.
Rotate dial or push [ e Y]/[Z] to select “CHAN Group,” and
then push [ENT].
Rotate dial or push [ r Y]/[Z] to select “ATIS,” and then push
[ENT].
Push [BACK] twice. t
Rotate dial or push [ y Ω]/[≈] to select the “ATIS” icon and
then push the softkey below the icon.
 •ATIScodeprogrammingscreenappears.
 •Push[CLEAR]tocanceltheprogramming,andgotothenormal
operating mode. In this case, the ATIS function is disabled. To
program the ATIS code, repeat the steps q and y.
Enter your ATIS code in the following manner: u
 •Selectadesirednumberusing[∫]/[√]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,rotatedialorselecteitherarrow,“←” or “→,”
then push [ENT] or dial.
Repeat step i u to enter all 10 digits.
After entering the 10 digit code, “FINISH” is automatically o
selected, and then push [ENT] or Dial to set it.
!0 The “ATIS CONFIRMATION” screen is displayed.
!1 Enter your ATIS code again for confirmation.
 •Enterinthesamemannerasstepsu through o.
!2 When your ATIS code programming is successfully com-
pleted, the screen as shown below is briefly displayed.
 •Afterthat,thenormaloperatingscreenisdisplayed.
The programmed ATIS code can be checked in the MENU
screen. (p. 85)
ATIS code programming ■ (For Dutch and German version transceivers)