Icom IC-M506EURO

18
New2001
DSC OPERATION
7
DSC address ID ■
Programming Individual ID D
A total of 100 DSC address IDs can be programmed and as-
signed a name of up to 10 characters.
Enter “INDIVIDUAL ID” in the DSC SETTINGS menu. q
Push [ADD]. w
 •The“INDIVIDUALID”programscreenisdisplayed.
Enter a desired individual ID in the following way: e
 •Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]ordialtosetit.
 •Tomovethecursor,rotatedialorselecteitherarrow,“←” or “→,”
then push [ENT] or dial.
 •Push[EXIT]toreturntothenormaloperatingmode.
 •Push[BACK]toreturntothepreviousscreen.
The first digit is ‘0,’ and the second digit is other than ‘0’
for a Group ID.
The first two digits are ‘0’ for any Coast station ID.
r Repeat step e to enter all 9 digits.
After entering the 9 digit code, push [ENT] or dial to set it. t
 •TheIDnameprogrammingscreenisdisplayed.
Enter a desired 10 digit ID name in the following way: y
 •Selectadesiredcharacterusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]ordialtosetit.
 •Tomovethecursor,rotatedialor select either arrow, “←” or “→,”
then push [ENT] or dial.
 •Push[123],[!$?]or[ABC]toselectacharactergroup.
After entering the ID name, select “FINISH” using [ u Y]/[Z]/
[Ω]/[≈], then push [ENT] to program it.
 •The“INDIVIDUALID”listscreenisdisplayed.
Push [MENU] to exit the MENU screen. i
MENU ➪ DSC SET ➪  Individual ID 
(Push [MENU]) (Select icon) (Rotate dial, then push [ENT].)