Icom IC-M803 - Page 14

3-4
6. REMOVING LOGIC UNIT
1) Remove the 8 screws from the rear case of the remote
controller.
Rear case
Screws × 8
2) Separate the rear case from the front panel as shown in
the illustration below.
Disconnect the data cable and the flat cable from the
front panel, and then remove the rear case from the front
panel.
Rear case
Front panel
Flat cable
Data cable
J9402J9402
J9201
J9201
3) Disconnect the speaker cable and 3 flat cables from the
LOGIC UNIT.
J9091J9091
J9092
J9092
J9401
J9401
J9151
J9151
LOGIC UNIT
Flat cable
Flat cables
Speaker cable
4) Remove the 11 screws from the LOGIC UNIT, and then
remove the shield cover and LOGIC UNIT from the front
panel.
Front panel
LOGIC UNIT
Shield cover
Screws × 11