Icom IC-V8000

22
4
REPEATER OPERATION
4
■ Reversed duplex mode
When the reversed duplex mode is selected, the receive fre-
quency shifts.
(Transmit frequency shifts in normal duplex mode.)
Each receive and transmit frequency is shown in the table
below with the following conditions;
Input frequency : 145.30 MHz
Direction : – (negative)
Offset frequency : 0.6 MHz
q Push [SET(LOCK)] to enter set mode.
w Push [SET(LOCK)] or [MW(S.MW)] several times until the
“REV” display appears as shown below.
e Rotate the tuning dial to turn the repeater lockout function
to ON or OFF.
r Push [TONE(T-SCAN)] to exit set mode.
z Push [
SET B(D-OFF)] to enter set mode.
x
Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] until
“REV” appears.
c Push [Y] or [Z] to set the reversed duplex
mode ON and OFF.
v Push [
CLR A(MW)] to exit set mode.
Push
SET
B
Reverse duplex mode is
turned ON.
USING
SET MODE
Reversed OFF ON
Rx frequency 145.30 MHz 144.70 MHz
Tx frequency 144.70 MHz 145.30 MHz