45
DTMF MEMORY ENCODER
9
■ Programming a DTMF code
DTMF codes are used for autopatching, controlling other
equipment, etc. The transceiver has 10 DTMF memory chan-
nels (d0–d9) for storage of often-used DTMF codes of up to
24 digits.
z Push [FUNC] then [
LOW
6(DTMF)] to turn the
DTMF encoder ON.
•“d” appears in place of the 100 MHz digit.
x Push [
SET
B(D-OFF)] to enter the DTMF mem-
ory programming condition.
c Push [Y] or [Z] to select the desired DTMF
memory channel.
v Push the desired digit keys.
• When the first digit is input, previous memory contents are
cleared automatically.
•“E” stands for “
MM
” and “F” stands for “# .”
• Push [Y]/[Z] and repeat this step if you make a mistake.
• The S/RF indicator shows the digit group. The indication in-
creases every 6 digits.
b Push [VFO/LOCK] to exit the programming condition.
• The [
CLR
A(MW)] key cannot be used to exit. If pushed, code “A”
is input and the previously programmed data is erased. Repro-
gram in such a case.
To Next Page
Loading...
