60
12
OTHER FUNCTIONS
12
DD
Offset frequency
Sets the duplex offset frequency within 0 to 20 MHz range.
During duplex (repeater) operation, transmit frequency (or re-
ceive when reverse function is set to ON) shifts the set fre-
quency. (default value may differ depending on versions)
DD
Reverse mode
Sets the reverse function ON and OFF (default).
DD
Tuning step
Selects tuning step from 5 (default), 10, 12.5, 15, 20, 25, 30
and 50 kHz for the tuning dial or [Y]/[Z] operation.
DD
Scan resume timer
Selects scan resume timer from SCT-15 (default), SCT-10,
SCT-5 and SCP-2.
• SCT-15/10/5 : Scan pauses for 15/10/5 sec., then re-
sumes.
• SCP-2 : Pause on a signal until signal disap-
pears, then resumes 2 sec. after the sig-
nal disappears.
DD
Transmit permission
Turns transmission permission ON and OFF. This function
can be set for each memory, call channel and VFO, indepen-
dently.
To Next Page
Loading...
