Icom ID-RP2010V - Software and Mode Settings; Utility Software Connection; DV;DD Switch Operation

7
3
INSTALLATION AND CONNECTION
■ Using the [DV/DD] switch (For only the ID-RP1200VD)
󰀨
L The mode selsction item of the Utility for ID-RP3 is disabled while operating in DD mode.
Unused switch
DV mode: RX
DD mode: Not used
DV mode: TX
DD mode: TX and RX
[DV/DD]
[DD]
[DV]
ID-RP1200VD
ID-RP2010V/ID-RP4010V
■ Connecting the Utility software
Sets the transmit and receive frequency, repeater call sign and other function settings using the Utility for ID-RP3.
Ask your dealer for details of the utility.
Connect the repeater and the Windows PC that the Utility for ID-RP3 is installed in, as shown below.

Download the latest USB driver and installation guide on the Icom website.
https://www.icomjapan.com/support/
PC
Type-B
USB cable (Supplied with the repeater)