10
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
1
2
3
4
SD CARD
LOCK
SD
NOTE:
• Before using the SD card, thoroughly read the
instructions that comes with the card.
•
corrupted or deleted.
-Drop, impact, or vibrate the SD card.
-Removing from the repeater while it is turned ON.
- Removing from the repeater while it is still accessing
the SD card.
• Do not touch the contacts of the SD card.
•
SD card with larger storage.
• The SD card has a certain lifetime. Data reading or
writing may not be possible after using it for a long
years.
• Icom will not be responsible for any damage caused by
data corruption on an SD card.
D Inserting
Insert the SD card as shown below.
L Insert the SD card into the slot until it locks in place, and
makes a ‘click’ sound.
L Be sure to check the card orientation before inserting.
NOTE:
• Format the SD card on your PC before inserting.
• Before formatting, backup its data onto your PC.
Formatting a card erases all its data.
• When inserting, folders will be created on the SD card.
IMPORTANT: Even if you have formatted an SD
card, some data may remain in the card. When you
dispose the card, be sure to physically destroy it to
■ Using an SD card
You can use an SD card of up to 2 GB, or an SDHC of
up to 32 GB. Icom has checked the compatibility with
the following SD and SDHC cards.
Manufacturer Type Storage
SanDisk
®
SD 2 GB
SDHC 4/8/16/32 GB
L The above list does not guarantee the card’s
performance.
L Throughout the rest of this document, the SD cards and
SDHC cards are simply called the SD card or the card.
The repeater uses the data saved in following formats:
•
• The voice data used for reading out callsign (wav).
• Firmware data for update (dat).
An SD card is required when:
•
•
• Importing the voice data used for reading out
callsign*.
* The Utility for ID-RP3 is required. Ask your dealer for
details of the utility.
q
w
D Removing
Push in the SD card until a ‘click’ sounds to unlock
(1), and then remove it from the slot (2).
To Next Page
Loading...
