8
INSTALLATION AND CONNECTION
3
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
1
2
■ Connecting multiple repeaters
Connect multiple repeaters using the supplied LAN
cable. This allows sharing one gateway server by
L Up to 4 repeaters are connectable.
L Only one DD mode ID-RP1200VD can be connected.
L
duplicated. The repeater ID is changeable using the Utility
for ID-RP3 (Tool > Rewrite ID).
L If you use a LAN cable other than the one supplied, use
one with a length of 3 meter or less.
L You cannot use with the ID-RP2C when the [CONT I/O
RPT] is set to [RPT].
Connection example:
ID-RP2010V
ID-RP4010V
LAN cable
[RPT1]
[RPT2]
[CONT I/O]
[RPT]
[CONT I/O]
[RPT]
LAN cable
[RPT1]
[RPT2]
LAN cable
[RPT1]
[RPT2]
ID-RP1200VD (DD mode)
ID-RP1200VD (DV mode)
[DD]
[DV]
[DD]
[DV]
■ Connecting to the ID-RP2C
Connect the ID-RP2C Repeater controller and assist
repeater as a gateway for the repeater.
L If you use a LAN cable other than the one supplied, use
one with a length of 3 meter or less.
L A Gateway server is usable with connecting the ID-RP2C.
L You cannot connect multiple repeaters when the
[CONT I/O RPT] is set to [CONT I/O].
L The ID-RP1200VD in DD mode is not usable.
[CONT I/O]
[RPT]
LAN cable
ID-RP2C
[CONT I/O]
[CONT I/O 1]
[CONT I/O 2]
LAN cable
ID-RP2010V or ID-RP4010V
[CONT I/O]
ID-RP1200VD
(DV mode)
[CONT I/O]
[RPT]
[DD]
[DV]
Connection example:
NOTE:
ID-RP2010V: 1, ID-RP4010V: 2, ID-RP1200VD: 3
If two ID-RP1200VD repeaters, one for DV mode and
the other for DD mode are connected, they must not
To Next Page
Loading...
