15
6
INFORMATION
D [LAN 2]
Connects to a Gateway server when
operating in the LTE mode.
L An optional LTE unit is required.
About the LED indication:
1LINK/ACT
• Lights when a cable is connected.
• Does not light when a cable is not
connected.
• Blinks while communicating
2SPEED
• Lights while communicating in
100BASE-TX.
• Does not light while communicating.
• Blinks while communicating in
10BASE-T, or not connected.
D [CONT I/O]
Connects to the LAN port of the ID-
RP2C using a supplied control cable,
when the repeater system is operating
as a gateway or assist repeater with
the ID-RP2C.
L Set [CONT I/O RPT] on the rear panel
to “CONT I/O,” when using this port.
■ Connectors
D [DC 13.8 V]
Accepts the regulated DC power of
13.8 V DC ±15% through the supplied
DC power cable.
RWARNING! NEVER reverse the
DC power cable polarity.
D [LAN 1]
Connects to a Gateway server when
operating in the Gateway repeater
mode.
About the LED indication:
1LINK/ACT
• Lights when a cable is connected.
• Does not light when a cable is not
connected.
• Blinks while communicating.
2SPEED
• Lights while communicating in
100BASE-TX.
• Does not light while communicating.
• Blinks while communicating in
10BASE-T, or not connected.
1 2
1 2
D Receiver
• Receive system:
ID-RP2010V/ID-RP4010V
ID-RP1200VD
RF direct sampling
Superheterodyne
• Sensitivity:
FM
DV
DD (ID-RP1200VD)
• Selectivity:
• Selectivity (ID-RP1200VD):
DV
DV
DD
• Intermodulation: ID-RP2010V/ID-RP4010V
ID-RP1200VD
–60 dB or less
–50 dB or less
• Receive spurious: 2 nW (–57 dBm) or less
• Spurious & image rejection: ID-RP2010V/ID-RP4010V
ID-RP1200VD
More than 55 dB
More than 50 dB
• Audio output power:
• AF output impedance:
■
To Next Page
Loading...
