Icom ID-RP2010V - Firmware Updates and Troubleshooting; Firmware Update Process; Troubleshooting Common Issues

13
5
MAINTENANCE
■ Troubleshooting

Icom service center.
PROBLEM POSSIBLE CAUSE SOLUTION REFERENCE
The repeater does not turn
ON.
• The connector or DC power
cable has a poor contact.
• The external power unit is
turned OFF.
• Blown fuse.
• Check the connector pins and then reconnect
the DC power cable.
• 
• Fix the problem, then replace the fuse.
p. 5
-
p. 12
Cannot turn OFF the repeater. • You are not holding down
[POWER].
• Hold down [POWER] until its green indicator
is turned OFF.
p. 2
Both [TX] and [RX] indicator
blink at same time.
• The repeater settings are
reset to default.
• Set operation frequency and tone. Ask dealer
for details.
The repeater does not
transmit output power, or
transmits low output power.
• Antenna or coaxial cable
has problems.
• Check, and if necessary, replace the coaxial
cable or the antenna connector.
-
Sensitivity is low and only
strong signals are heard.
• Antenna or coaxial cable
has problems.
• Check, and if necessary, replace the coaxial
cable or the antenna connector.
-
There was a problem with the
operation.
• Caused by external factors
such as static electricity.
• Turn OFF the repeater, remove and reattach
the external power unit, and then turn ON the
repeater.
-
The repeater does not repeat
the received signal.
• Incorrect settings. • Check the mode setting (FM or DV).
• Check the operation frequency setting and
tone setting.
• Check the callsign setting and IP address
setting.
Ask dealer
for details.
Cannot connect to other
repeater sites.
• Cannot connect to the
Gateway server from the
WAN port.
• 
enabled on your router.
-
The repeater does not
operate as a Gateway
• The ID-RP2C is connected. • Connect a Gateway server to the ID-RP2C. p. 1
■ Detaching the rack handle
You can detach the rack handle, depending on the

Allen wrench to detach, as shown below.
■ About the rmware

or improve functions. Ask you dealer for details of

L Update the firmware using a formatted SD card. Extract
the downloaded firmware and copy it to the “Firmware”
folder on the SD card (p. 11).
Allen wrench
Rack handle