ICON Cube - Cube Pro

Cube Pro
Specifications (Measured at 48KHz Sample Rate)(Continues)
Line Inputs 1/4(Unbanced):
Line Outputs 1/4 (Unbanced):
Headphone Outputs: 1 & 2 (at Maximum Volume; Into 100 Ohm load):
Frequency Response:...............................22Hz to 22kHz (+/-0.1dB)
Dynamic Range: ......................................100dB, A-weighted
Signal-to-Noise Ratio: ..............................-100dB, A-weighted
THD+N: ....................................................<0.0061% (-90dB)
Crosstalk: .................................................-100dB @ 1kHz
Nominal Input Level: ...............................Unbalanced: +4dBV, typical;
Maximum Input level: .............................Unbalanced: +11dBV, typical;
Input Impedance: ....................................10K Ohms, typical
Frequency Response: ..............................22Hz 22kHz (+/-0.1dB)
Dynamic Range: .......................................102dB, A-weighted
Signal-to-Noise Ratio: ..............................-102dB, A-weighted
THD+N: ....................................................<0.003% (-90 dB)
Crosstalk: .................................................-100dB @ 1kHz
Nominal Output Level: ............................Unbalanced: +4dBV, typical;
Maximum Output Level: ..........................+11dBV, typical;
Output Impedance: .................................150 Ohm
Load Impedance: .....................................600 Ohm minimum
Frequency Response: ..............................22Hz to 22kHz (+/-1dB)
Power into Ohms: ....................................90 mW into 100 Ohms
THD+N: ....................................................<0.06% (-66dB)
Signal-to-Noise Ratio: ..............................-90dB, A-weighted
Max Output Level into 100 Ohms: ...........+2.0dBV, typical
Output Impedance: .................................75 Ohm
Load Impedance: .....................................32 to 600 Ohms